84751R
1.INSPECT REAR SEAT HEATER SWITCH (for LH Side)
Check the resistance.
| *a | Component without harness connected
(Rear Seat Heater Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
||
| 5 (IG) - 2 (E) | Switch pressed | Below 1 Ω |
| 5 (IG) - 2 (E) | Switch not pressed | 10 kΩ or higher |
Inspect the indicator operation.
Apply auxiliary battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch indicator LED illuminates.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
||
| Auxiliary battery positive (+) → 5 (IG)
Auxiliary battery negative (-) → 4 (IND) |
Switch pressed | Indicator LED illuminates |
Inspect the illumination operation.
Apply auxiliary battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
|
| Auxiliary battery positive (+) → 6 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-) |
LED illuminates |
84751R
2.INSPECT REAR SEAT HEATER SWITCH (for RH Side)
Check the resistance.
| *a | Component without harness connected
(Rear Seat Heater Switch) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
||
| 5 (IG) - 2 (E) | Switch pressed | Below 1 Ω |
| 5 (IG) - 2 (E) | Switch not pressed | 10 kΩ or higher |
Inspect the indicator operation.
Apply auxiliary battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch indicator LED illuminates.
| Measurement Condition | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
||
| Auxiliary battery positive (+) → 5 (IG)
Auxiliary battery negative (-) → 4 (IND) |
Switch pressed | Indicator LED illuminates |
Inspect the illumination operation.
Apply auxiliary battery voltage to the rear seat heater switch connector, and check that the rear seat heater switch LED illuminates.
| Measurement Condition | Specified Condition |
|---|---|
|
If the result is not as specified, replace the rear seat heater switch. |
|
| Auxiliary battery positive (+) → 6 (ILL+)
Auxiliary battery negative (-) → 1 (ILL-) |
LED illuminates |