87510L
1.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH (for Driver Side)
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly LH. |
||
| A-1 - B-5 | Always 20°C (68°F) | 2.9 to 3.4 Ω |
| A-2 - B-7 | Always 20°C (68°F) | 1.6 to 1.9 Ω |
87510K
2.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH (for Front Passenger Side)
w/o Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly RH. |
||
| A-1 - B-5 | Always 20°C (68°F) | 2.9 to 3.4 Ω |
| A-2 - B-7 | Always 20°C (68°F) | 1.6 to 1.9 Ω |
for Standard Seat Type, w/ Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly RH. |
||
| A-1 - A-2 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
| A-1 - A-6 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
| A-1 - B-2 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
for Sports Seat Type, w/ Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly RH. |
||
| A-1 - A-2 | Always 20°C (68°F) | 5.0 to 6.1 Ω |
| A-1 - A-6 | Always 20°C (68°F) | 5.0 to 6.1 Ω |
| A-1 - B-2 | Always 20°C (68°F) | 5.0 to 6.1 Ω |
87510K
3.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY RH (for Driver Side)
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly RH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly RH. |
||
| A-1 - B-5 | Always 20°C (68°F) | 2.9 to 3.4 Ω |
| A-2 - B-7 | Always 20°C (68°F) | 1.6 to 1.9 Ω |
87510L
4.INSPECT FRONT SEAT CUSHION HEATER ASSEMBLY LH (for Front Passenger Side)
w/o Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly LH. |
||
| A-1 - B-5 | Always 20°C (68°F) | 2.9 to 3.4 Ω |
| A-2 - B-7 | Always 20°C (68°F) | 1.6 to 1.9 Ω |
for Standard Seat Type, w/ Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly LH. |
||
| A-1 - A-2 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
| A-1 - A-6 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
| A-1 - B-2 | Always 20°C (68°F) | 4.6 to 5.5 Ω |
for Sports Seat Type, w/ Climate Control Seat System:
Check the resistance.
Measure the resistance according to the value(s) in the table below.
| *a | Connector A | *b | Connector B |
| *c | Component without harness connected
(Seat Heater Assembly LH) |
- | - |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
|
If the result is not as specified, replace the seat heater assembly LH. |
||
| A-1 - A-2 | Always 20°C (68°F) | 5.0 to 6.1 Ω |
| A-1 - A-6 | Always 20°C (68°F) | 5.0 to 6.1 Ω |
| A-1 - B-2 | Always 20°C (68°F) | 5.0 to 6.1 Ω |