Inspect the fuses for circuits related to this system before performing the following procedure.
Clear the DTCs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
Recheck for DTCs and check if the same DTC is output again.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>BLIND SPOT MONITOR SYSTEM>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N19 RCTA buzzer (blind spot monitor buzzer) connector.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| N19-1 (BZP) - Body ground | Ignition switch ON | 11 to 14 V |
| N19-2 (BZN) or Q13-3 (BUZ) - Body ground | Below 1 V | |
| N19-2 (BZN) - N19-1 (BZP) | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Disconnect the N19 RCTA buzzer (blind spot monitor buzzer) connector.
Disconnect the Q13 blind spot monitor sensor RH connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| N19-2 (BZN) - Q13-3 (BUZ) | Always | Below 1 Ω |
| N19-2 (BZN) or Q13-3 (BUZ) - Body ground | Always | 10 kΩ or higher |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
|---|---|---|
| N19-2 (BZN) or Q13-3 (BUZ) - Body ground | Ignition switch ON | Below 1 V |
| N19-1 (BZP) - Body ground | Ignition switch ON | 11 to 14 V |
| N19-1 (BZP) - Body ground | Ignition switch off | Below 1 V |
| Proceed to |
|---|
| OK |
| NG |
OK
NG
Replace the RCTA Buzzer (Blind Spot Monitor Buzzer) with a new or known good one and check if the same malfunction recurs.
Click hereAudio / Visual / Telematics>PARK ASSIST / MONITORING>REAR CROSS TRAFFIC ALERT BUZZER>REMOVAL
Malfunction does not reoccur (returns to normal).
| Proceed to |
|---|
| OK |
| NG |
OK
NG