84010D
1.INSPECT INTELLIGENT MANUAL TRANSMISSION SWITCH (COMBINATION SWITCH)
Inspect the iMT mode switch:
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (S) - 6 (GND) | iMT mode switch being pushed and held | Below 1 Ω |
| iMT mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).
Inspect the NORMAL mode switch:
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (B) - 6 (GND) | NORMAL mode switch being pushed and held | Below 1 Ω |
| NORMAL mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).
Inspect the SPORT mode switch:
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (P) - 6 (GND) | SPORT mode switch being pushed and held | Below 1 Ω |
| SPORT mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).
Inspect the ECO mode switch:
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 10 (ECU) - 6 (GND) | ECO mode switch being pushed and held | Below 1 Ω |
| ECO mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).
Check that the SNOW mode switch:
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 3 (2ND) - 6 (GND) | SNOW mode switch being pushed and held | Below 1 Ω |
| SNOW mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).
Check that the illumination illuminates.
| *a | Component without harness connected
(Intelligent Manual Transmission Switch (Combination Switch)) |
Apply battery voltage between the terminals of the switch and check the illumination condition of the intelligent manual transmission switch (combination switch).
| Measurement Condition | Specified Condition |
| Battery positive (+) → 5 (MSW+)
Battery negative (-) → 1 (MSW-) |
Illuminates |
If the result is not as specified, replace the intelligent manual transmission switch (combination switch).