The skid control ECU (brake actuator assembly) communicates with the engine stop and start ECU via CAN communication.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| U110387 | Lost Communication with Stop and Start Control Module Missing Message | The +BS terminal voltage is between 9.6 and 16.5 V, the vehicle speed is 6 km/h (4 mph) or more, data cannot be received from engine stop and start ECU continuously for 2 seconds or more. | ·
CAN communication system ·
Engine stop and start ECU ·
Skid control ECU (brake actuator assembly) |
DTC stored | An electric parking brake system malfunction is displayed on the multi-information display. |
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Operate the GTS to clear the codes. Enter the following menus: Chassis / Brake/EPB / Trouble Codes.
Press the DTC clear button.
Turn the ignition switch off.
Turn the ignition switch to ON.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| DTCs for related systems are output together with DTC U110387. | A |
| U110387 is output. | B |
| DTCs are not output. | C |
A
B
C
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING