Home › General › SPECIFICATIONS › P710 HYBRID TRANSMISSION / TRANSAXLE › 2018.10–2019.02
RM3620E _V1 General _077121 SPECIFICATIONS _0378971 P710 HYBRID TRANSMISSION / TRANSAXLE F

SPECIFICATIONS  P710 HYBRID TRANSMISSION / TRANSAXLE  SERVICE DATA  


HYBRID TRANSAXLE SYSTEM
Maintenance mode engine idle speed Hybrid transaxle fluid temperature Hybrid transaxle fluid pressure
900 to 1000 rpm 20 to 50°C (68 to 122°F) 9.8 kPa (0.1 kgf/cm2, 1 psi) or more

HYBRID TRANSAXLE FLUID
Hybrid transaxle fluid standard capacity (for Reference) Classification
3.9 liters (4.1 US qts, 3.4 Imp. qts) Toyota Genuine ATF WS

HYBRID TRANSAXLE OIL SEAL
Front drive shaft oil seal RH Standard depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)
Front drive shaft oil seal LH Standard depth -0.5 to 0.5 mm (-0.0197 to 0.0197 in.)

INPUT SHAFT OIL SEAL
Input shaft type T oil seal Standard depth 1.9 to 2.7 mm (0.0748 to 0.106 in.)

SHIFT LEVER
Wire harness:
Tester Connection Condition Specified Condition
5 (IG) - Body ground Power switch on (IG) 11 to 14 V
Power switch off Below 1 V
4 (STP) - Body ground Ready ON, brake pedal depressed 11 to 14 V
Ready ON, brake pedal released Below 1 V
1 (E) - Body ground Always Below 1 Ω
Shift lock solenoid:
Tester Connection Condition Specified Condition
4 (P) - 3 (E2) Shift lever in P 10 kΩ or higher
Shift lever not in P Below 1 Ω
1 (SLS+) - 2 (SLS-) Always 112 Ω
Transmission Control Switch (for LHD):
Tester Connection Condition Specified Condition
4 (IG) - 5 (S) Shift lever in S, "+" or "-" Below 1 Ω
Shift lever not in S, "+" or "-" 10 kΩ or higher
3 (SFTU) - 2 (E) Shift lever held in "+" (Up-shift) Below 1 Ω
Shift lever not held in "+" (Up-shift) 10 kΩ or higher
1 (SFTD) - 2 (E) Shift lever held in "-" (Down-shift) Below 1 Ω
Shift lever not held in "-" (Down-shift) 10 kΩ or higher
Transmission Control Switch (for RHD):
Tester Connection Condition Specified Condition
4 (IG) - 5 (S) Shift lever in S, "+" or "-" Below 1 Ω
Shift lever not in S, "+" or "-" 10 kΩ or higher
1 (SFTU) - 2 (E) Shift lever held in "+" (Up-shift) Below 1 Ω
Shift lever not held in "+" (Up-shift) 10 kΩ or higher
3 (SFTD) - 2 (E) Shift lever held in "-" (Down-shift) Below 1 Ω
Shift lever not held in "-" (Down-shift) 10 kΩ or higher

COMBINATION SWITCH
NORMAL Mode Switch:
Tester Connection Condition Specified Condition
8 (B) - 13 (GND) NORMAL mode switch being pushed and held Below 1 Ω
NORMAL mode switch not pushed 10 kΩ or higher
SPORT Mode Switch:
9 (P) - 13 (GND) SPORT mode switch being pushed and held Below 1 Ω
SPORT mode switch not pushed 10 kΩ or higher
ECO Mode Switch:
Tester Connection Condition Specified Condition
7 (ECU) - 13 (GND) ECO mode switch being pushed and held Below 1 Ω
ECO mode switch not pushed 10 kΩ or higher
Illumination Illuminates:
Condition Specified Condition
Battery positive (+) → Terminal 12 (ILL+)
Battery negative (-) → Terminal 1 (ILL-)
Illuminates

SHIFT LEVER POSITION SENSOR
Tester Connection Condition Specified Condition
7 (+B) - 3 (PR) Shift lever in P Below 1 Ω
7 (+B) - 4 (PNB) Below 1 Ω
7 (+B) - 8 (P) Below 1 Ω
7 (+B) - 1 (DB1), 2 (N), 6 (DB2) or 9 (R) Shift lever in P 10 kΩ or higher
7 (+B) - 3 (PR) Shift lever in R Below 1 Ω
7 (+B) - 9 (R) Below 1 Ω
7 (+B) - 1 (DB1), 2 (N), 4 (PNB), 6 (DB2) or 8 (P) Shift lever in R 10 kΩ or higher
7 (+B) - 2 (N) Shift lever in N Below 1 Ω
7 (+B) - 4 (PNB) Below 1 Ω
7 (+B) - 1 (DB1), 3 (PR), 6 (DB2), 8 (P) or 9 (R) Shift lever in N 10 kΩ or higher
7 (+B) - 1 (DB1) Shift lever in D or S Below 1 Ω
7 (+B) - 6 (DB2) Below 1 Ω
7 (+B) - 2 (N), 3 (PR), 4 (PNB), 8 (P) or 9 (R) Shift lever in D or S 10 kΩ or higher

SHIFT PADDLE SWITCH
No. 1 Transmission Shift Switch Assembly:
Tester Connection Condition Specified Condition
1 (SDN) - 2 (ECC) "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω
"-" (Down shift) shift paddle switch not operated 1 MΩ or higher
1 (SDN) - 3 (ECC') "-" (Down shift) shift paddle switch operated and held Below 2.5 Ω
"-" (Down shift) shift paddle switch not operated 1 MΩ or higher
No. 2 Transmission Shift Switch Assembly:
Tester Connection Condition Specified Condition
1 (SUP) - 2 (ECC') "+" (Up shift) shift paddle switch operated and held Below 2.5 Ω
"+" (Up shift) shift paddle switch not operated 1 MΩ or higher