When using a vise, place aluminum plates between the part and vise.
When using a vise, do not overtighten it.
1.INSPECT FRONT DRIVE SHAFT ASSEMBLY
Check that there is no excessive play in the radial direction of the outboard joint.
Check that the inboard joint slides smoothly in the thrust direction.
Check that there is no excessive play in the radial direction of the inboard joint.
Check the boots for damage.
| *A | for LH Side |
| *B | for RH Side |
Check whether the drive shaft dimension (A) and (B) are within specification.
Keep the drive shaft assembly level during inspection.
for Automatic Transaxle:
| for LH Side | 591.2 mm (1.94 ft.) |
| for RH Side | 918.0 mm (3.01 ft.) |
for Manual Transaxle:
| for LH Side | 607.6 mm (1.99 ft.) |
| for RH Side | 909.4 mm (2.97 ft.) |
for CVT:
| for LH Side | 603.2 mm (1.98 ft.) |
| for RH Side | 905.0 mm (2.97 ft.) |