These DTCs are stored if there is a malfunction in the CAN communication system connected to the clearance warning ECU assembly.
If CAN communication system DTCs are stored, they may also be stored in other systems.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| U010087 | Lost Communication with ECM/PCM "A" Missing Message | The clearance warning ECU assembly is unable to receive data from the ECM for 5.12 seconds or more | CAN communication system |
| U012587 | Lost Communication With Multi-axis Acceleration Sensor Module Missing Message | The clearance warning ECU assembly is unable to receive data from the airbag sensor assembly for 0.72 seconds or more | CAN communication system |
| U012687 | Lost Communication with Steering Angle Sensor Module Missing Message | The clearance warning ECU assembly is unable to receive data from the steering sensor for 5.04 seconds or more | CAN communication system |
| U012987 | Lost Communication with Brake System Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the skid control ECU for 5 seconds or more | CAN communication system |
| U014087 | Lost Communication with Body Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the main body ECU (multiplex network body ECU) for 5 seconds or more | CAN communication system |
| U015587 | Lost Communication with Instrument Panel Cluster (IPC) Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the combination meter assembly for 5 seconds or more | CAN communication system |
| U016487 | Lost Communication with HVAC Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the air conditioning amplifier assembly for 5 seconds or more | CAN communication system |
| U110387 | Lost Communication with Stop and Start Control Module Missing Message | The clearance warning ECU assembly is unable to receive data from the engine stop and start ECU for 0.76 seconds or more | CAN communication system |
Using the GTS, check for DTCs according to the prompts on the screen.
After turning the engine switch from off to on (IG), wait 10 seconds or more before checking for DTCs.
Clear the DTCs according to the screen on the GTS.
Recheck for DTCs.
No DTCs are output.
If CAN communication system DTCs are stored, they may also be stored in other systems.
If the CAN communication system has been inspected and repaired in other systems, the DTCs will not be output when rechecking for DTCs.
If these DTCs are output frequently, duplicate the conditions that caused the problem symptoms and perform the inspection again, even though DTCs were not output when rechecking for DTCs.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG