TROUBLESHOOTING PRECAUTIONS
Unless otherwise stated, ensure that the power switch is off when removing or installing parts.
The electric parking brake may still operate up to 20 seconds after the power switch is turned off. Before disconnecting connectors or fuses, turn the power switch off and wait 20 seconds or more.
HANDLING PRECAUTIONS
When tilting the vehicle to perform work after parking the vehicle on a level surface, since a sufficient amount of braking force may not be generated, make sure to pull the electric parking brake switch 2 times (2 lock operations).
The electric parking brake determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag sensor assembly).
When the electric parking brake switch is pulled 2 times (2 lock operations), the system uses the maximum amount of braking force.
After replacing the parking brake ECU assembly, the parking brake indicator light blinks when the power switch is turned on (IG) for the first time. To turn off the parking brake indicator light after replacing the parking brake ECU assembly, operate the electric parking brake switch (integration control and panel assembly) to the lock side then to the release side.
PRECAUTIONS FOR TOWING VEHICLES
For towing precautions: Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
PARKING BRAKE FORCED RELEASE METHOD
For the parking brake forced release method: Click hereBrake>PARKING BRAKE>FORCED RELEASE (w/o Vacuum Brake Booster)>OPERATION METHOD