If the electric parking brake is used continuously, the parking brake actuator assembly overheat prevention stops the system.
This DTC is stored to protect the system and is not a malfunction.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13AA | EPB High Temperature | Both of following conditions are met:
1.
Electric parking brake is operating 2.
Lock and release operations are performed without 2 second interval 10 times; or lock and release operations are performed without 2 second interval 4 times, and target current is not achieved during lock control |
Overheat due to continuous use of system | Yes | A message is displayed on the multi-information display indicating electric parking brake system operation is stopped due to high temperatures.
|
| Vehicle Condition | |||
| Pattern 1 | Pattern 2 | ||
| Diagnosis Condition | Electric parking brake operating | ○ | ○ |
| Malfunction Status | Lock and release operations are performed within less than 2 seconds | ○ | - |
| Lock and release operations are performed within less than 2 seconds and target current is not achieved during lock control | - | ○ | |
| Detection Time | The malfunction status repeats 10 times | The malfunction status repeats 4 times or more | |
| Trip Count | 1 trip | 1 trip | |
If the conditions match either of these patterns, a DTC will be output.
Wait for approximately 1 minute.
Check if the overheat warning has disappeared.
If the display returns to normal and the electric parking brake can be operated, clear the DTC.
| Proceed to |
|---|
| NEXT |
NEXT