Home › Brake › PARKING BRAKE › ELECTRIC PARKING BRAKE SYSTEM (w/ Vacuum Brake Booster)
RM3620E _54 Brake _076413 PARKING BRAKE _0378277 ELECTRIC PARKING BRAKE SYSTEM(w/ Vacuum Brake Booster) L

PARKING BRAKE  ELECTRIC PARKING BRAKE SYSTEM(w/ Vacuum Brake Booster)  PRECAUTION  


TROUBLESHOOTING PRECAUTIONS


a.

Unless otherwise stated, ensure that the ignition switch is off when removing or installing parts.


b.

The electric parking brake may still operate up to 20 seconds after the ignition switch is turned off. Before disconnecting connectors or fuses, turn the ignition switch off and wait 20 seconds or more.



HANDLING PRECAUTIONS


a.

When tilting the vehicle to perform work after parking the vehicle on a level surface, since a sufficient amount of braking force may not be generated, make sure to pull the electric parking brake switch (brake warning switch assembly)*1 or electric parking brake switch (integration control and panel assembly)*2 2 times (2 lock operations).

*1: for Manual Transaxle

*2: except Manual Transaxle

HINT:
·

The electric parking brake determines the amount of force used to operate the parking brake according to the tilt angle detected by the deceleration sensor (airbag sensor assembly).

·

When the electric parking brake switch (brake warning switch assembly)*1 or electric parking brake switch (integration control and panel assembly)*2 is pulled 2 times (2 lock operations), the system uses the maximum amount of braking force.

*1: for Manual Transaxle

*2: except Manual Transaxle




b.

When the skid control ECU (brake actuator assembly) is replaced, the parking brake indicator light flashes the first time the ignition switch is turned to ON in order to inform the skid control ECU (brake actuator assembly) that the condition of the electric parking brake switch (brake warning switch assembly)*1 or electric parking brake switch (integration control and panel assembly)*2 cannot be recognized. Once the electric parking brake switch (brake warning switch assembly)*1 or electric parking brake switch (integration control and panel assembly)*2 is operated, the skid control ECU (brake actuator assembly) recognizes the lock or release condition and the parking brake indicator light turns off.

*1: for Manual Transaxle

*2: except Manual Transaxle



PRECAUTIONS FOR TOWING VEHICLES


a.

For towing precautions: Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION



PARKING BRAKE FORCED RELEASE METHOD


a.

For the parking brake forced release method: Click hereBrake>PARKING BRAKE>FORCED RELEASE (w/ Vacuum Brake Booster)>OPERATION METHOD