Home › Brake › BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS › ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/ Vacuum Brake Booster)
RM3620E _54 Brake _076410 BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS _0379311 ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/ Vacuum Brake Booster) D

BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS  ELECTRONICALLY CONTROLLED BRAKE SYSTEM(w/ Vacuum Brake Booster)  VEHICLE CONTROL HISTORY  


DESCRIPTION


·

Vehicle Control History is a function that captures and stores ECU data when triggered by specific vehicle behavior.

·

It may be possible to determine the cause of the malfunction by checking the vehicle history information and freeze frame data.

·

The number of possible stored Freeze Frame Data sets, whether multi Freeze Frame Data is available, the number of freeze frame points, Freeze Frame Data items, the ECU internal range, etc., is different depending on the stored group.

·

The stored data items for Vehicle Control History Freeze Frame Data are different depending on the stored group. When the value of a data item does not change across all points, only the value of the detection point will be displayed. The contents of the Freeze Frame Data is almost the same as that of the Data List.

Click hereBrake>BRAKE CONTROL / DYNAMIC CONTROL SYSTEMS>ELECTRONICALLY CONTROLLED BRAKE SYSTEM (w/ Vacuum Brake Booster)>DATA LIST / ACTIVE TEST



PRECAUTIONS


·

As Vehicle Control History may be overwritten whenever the trigger conditions are met, make sure to save Vehicle Control History before performing any inspections.

·

As Vehicle Control History may be stored when performing an Active Test, learning, etc., make sure to clear the Vehicle Control History before returning the vehicle to the customer.



CHECK VEHICLE CONTROL HISTORY (ELECTRONICALLY CONTROLLED BRAKE SYSTEM AND ELECTRIC PARKING BRAKE SYSTEM)


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Brake/EPB / Utility / Vehicle Control History (RoB).

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055


Vehicle Control History Item (Electronically Controlled Brake System and Electric Parking Brake System)
FFD Group Code Tester Display Measurement Item Diagnostic Note
- X0451 FL Speed Sensor Wrong Installation History of front speed sensor LH being installed incorrectly -
- X0452 FR Speed Sensor Wrong Installation History of front speed sensor RH being installed incorrectly -
- X0453 RL Speed Sensor Wrong Installation History of rear speed sensor LH (rear axle hub and bearing assembly LH) being installed incorrectly*1
History of rear speed sensor LH being installed incorrectly*2
-
- X0454 RR Speed Sensor Wrong Installation History of rear speed sensor RH (rear axle hub and bearing assembly RH) being installed incorrectly*1
History of rear speed sensor RH being installed incorrectly*2
-
- X0455 Steering Sensor Wrong Installation History of steering sensor being installed incorrectly -
- X0456 Yaw Rate Sensor Wrong Installation History of yaw rate sensor (airbag sensor assembly) being installed incorrectly -
- X2079 Communication Error from Brake Control Module to Engine Control Module History of receiving an invalid communication signal from ECM -
- X2086 SRS Airbag Malfunction History of receiving an abnormal secondary collision brake control request signal from airbag sensor assembly -
- X2087 Engine Malfunction History of receiving an SFI system abnormal signal from ECM -
- X208A Zero Point Calibration of Steering Sensor Undone History of failure in acquiring steering sensor zero point even after the vehicle is driven in a straight line at a vehicle speed of 15 km/h (9 mph) or more for 115 seconds or more with the steering sensor zero point calibration cleared -
- X208B EPB Motor Continuous Operation Request History of system suspended to prevent overheat of parking brake actuator assembly when electric parking brake was used repeatedly
HINT:

EPB stands for electric parking brake.


- X20A4 Booster Failure Control History of control failure operation -
- X20A9 ABS Continuous Operation Request History of ABS being operated for 60 seconds or more -
- X20AA VSC Continuous Operation Request History of VSC being operated for 10 seconds or more -
- X2105 Shift N Switch Malfunction History of receiving an abnormal neutral position switch signal via CAN communication for Manual Transaxle

*1: for 2WD

*2: for 4WD/AWD

CLEAR VEHICLE CONTROL HISTORY (ELECTRONICALLY CONTROLLED BRAKE SYSTEM AND ELECTRIC PARKING BRAKE SYSTEM)


a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

Enter the following menus: Chassis / Brake/EPB / Utility / Vehicle Control History (RoB).

Chassis > Brake/EPB > Utility
Tester Display
Vehicle Control History (RoB)
50005 435 1055

f.

Press the DTC clear button.

NOTICE:

By performing this procedure, all stored Vehicle Control History items will be cleared.




VEHICLE CONTROL HISTORY (AIRBAG SYSTEM)


HINT:

A part of the control history can be confirmed using the vehicle control history.

w/ Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (for Gasoline Model with Occupant Classification System)>VEHICLE CONTROL HISTORY

w/o Occupant Classification System: Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>AIRBAG SYSTEM (w/o Occupant Classification System)>VEHICLE CONTROL HISTORY