WHEN USING GTS
Strictly obey all traffic rules and regulations.
Do not drive the vehicle with the GTS cable contacting the pedals, shift lever or steering wheel.
Driving the wheel with the GTS cable contacting these areas could impede vehicle control, resulting in a serious accident.
Do not operate the GTS while driving the vehicle.
Operating the GTS while driving the vehicle will prevent you from paying sufficient attention to vehicle surroundings, and could result in a serious accident.
INITIALIZATION
Perform Registration (VIN registration) after replacing the ECM.
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>REGISTRATION
Perform Learning Value Reset and Idle Learning after replacing or servicing parts related to engine operation.
Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/ Canister Pump Module)>INITIALIZATION
Make sure to perform Reset Memory (A/T initialization), when replacing the automatic transaxle assembly, ECM or engine assembly.
Click hereDrivetrain>UB80E (AUTOMATIC TRANSMISSION / TRANSAXLE)>AUTOMATIC TRANSAXLE SYSTEM>INITIALIZATION
When the cable is disconnected from the negative (-) battery terminal, initialize the following system(s) after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION