Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM
RM3620E _52 Drivetrain _076960 GF1A TRANSFER / 4WD / AWD _0379782 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM U

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  TERMINALS OF ECU  


CHECK 4WD ECU ASSEMBLY


C270073E15
3.385,0.135 3.813,0.438 0.427,0.302 3.5,0.208 3.969,0.375 0.469,0.167 10 false N5

a.

Measure the voltage and resistance of the connector.

Terminal No. (Symbol) Wiring Color Terminal Description Condition Specified Condition

*1: except Manual Transaxle (for LHD)

*2: for Manual Transaxle (for LHD)

N5-11 (OMS) - N5-4 (GND) GR - W-B Multi-terrain select switch (integration control and panel assembly) input Ignition switch ON (Switch not operated) 11 to 14 V
N5-7 (OMSG) - N5-4 (GND) L - W-B Multi-terrain select switch (integration control and panel assembly) ground Always Below 1 Ω
N5-6 (CANH) - N5-5 (CANL) L - W HIGH-level CAN bus wire - LOW-level CAN bus wire Cable disconnected from negative (-) battery terminal 54 to 69 Ω
N5-4 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω
N5-3 (IG1) - N5-4 (GND) L - W-B*1
LA-Y - W-B*2
Power source voltage Ignition switch ON 11 to 14 V
N5-2 (SLC+) - N5-1 (SLC-) W - B 4WD linear solenoid signal D position, Idling Pulse generation (See waveform 1)

If the result is not as specified, the 4WD ECU assembly may have a malfunction.


b.
C170221E01
2.917,1.729 3.271,1.865 0.354,0.135 10 GND

Using an oscilloscope, check the waveform 1.

Waveform 1 (Reference)
Item Content
Terminal No. (Symbol) N5-2 (SLC+) - N5-1 (SLC-)
Tester Range 2 V/DIV., 1 msec./DIV.
Condition D position, Idling