Home › Drivetrain › GF1A (TRANSFER / 4WD / AWD) › DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM
RM3620E _52 Drivetrain _076960 GF1A TRANSFER / 4WD / AWD _0379782 DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM J

GF1A TRANSFER / 4WD / AWD  DYNAMIC TORQUE CONTROL 4WD/AWD SYSTEM  4WD Warning Light does not Come ON  


CAUTION / NOTICE / HINT

PROCEDURE

1.CHECK HARNESS AND CONNECTOR
a.

Check that there is no looseness at the locking and connecting parts of the 4WD ECU assembly connector.

OK:

No looseness at the locking and connecting parts



b.

Disconnect the N5 4WD ECU assembly connector.


c.

Check the connector case and the terminal for deformation and corrosion.

OK:

No deformation or corrosion



d.

Connect the N5 4WD ECU assembly connector.


Result:
Proceed to
OK
NG



OK

2.CHECK 4WD WARNING MESSAGE

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

2.CHECK 4WD WARNING MESSAGE
a.

Turn the ignition switch off.


b.

Connect the GTS to the DLC3.


c.

Turn the ignition switch to ON.


d.

Turn the GTS on.


e.

According to the display on the GTS, read the Data List.

Chassis > Four Wheel Drive > Data List
Tester Display Measurement Item Range Normal Condition Diagnostic Note
4WD Warning Light 4WD/AWD warning (multi-information display) OFF / ON OFF: Warning off
ON: Warning on
-
Chassis > Four Wheel Drive > Active Test
Tester Display Measurement Item Control Range Diagnostic Note
4WD Warning Light 4WD/AWD warning (multi-informationdisplay) Warning ON/OFF Observe combination meter assembly
Chassis > Four Wheel Drive > Active Test
Active Test Display
4WD Warning Light
Data List Display
4WD Warning Light
50004 118 2 7

Result:
Result Proceed to
Data List display does not switch ON/OFF A
Data List display switches ON/OFF B



A

B

GO TO METER / GAUGE SYSTEM (HOW TO PROCEED WITH TROUBLESHOOTING)