Home › Vehicle Exterior › DOOR / HATCH › POWER BACK DOOR SYSTEM (for Gasoline Model)
RM3620E _59 Vehicle Exterior _076335 DOOR / HATCH _0376805 POWER BACK DOOR SYSTEM(for Gasoline Model) D

DOOR / HATCH  POWER BACK DOOR SYSTEM(for Gasoline Model)  INITIALIZATION  


INITIALIZE MULTIPLEX NETWORK DOOR ECU


NOTICE:

Initialization of the multiplex network door ECU (back door initial position learning) is necessary if the following work procedures are performed while the back door is open.

·

The cable to the negative (-) battery terminal is connected.

·

A power source system fuse of the power back door system is disconnected and reconnected.

·

The multiplex network door ECU is replaced or the connectors are disconnected.


The power back door does not operate unless the multiplex network door ECU is initialized.


HINT:
·

Initialization is not necessary if the above procedures are performed while the back door is closed.

·

When disconnecting the negative (-) battery terminal, some systems need to be initialized after the negative (-) battery terminal is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



a.

Initialization operation

i.

Fully close the back door by hand.