DTC B1795 is stored when a malfunction is detected in the occupant detection ECU.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B1795 | Occupant Classification ECU Malfunction | Occupant detection ECU malfunction | Occupant detection ECU |
When disconnecting the cable from the negative (-) auxiliary battery terminal while performing repairs, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
When DTC B1650 is stored as a result of troubleshooting for the airbag system, check the DTCs stored in the occupant detection ECU. When DTC B1795 is output, perform troubleshooting for this DTC first.
Clear the DTCs stored in the occupant detection ECU.
Clear the DTCs stored in the airbag sensor assembly.
Turn the power switch off.
Turn the power switch on (IG), and wait for at least 60 seconds.
Check the DTCs stored in the occupant detection ECU.
| Proceed to |
|---|
| DTC B1795 is output. |
| DTC B1795 is not output. |
Codes other than DTC B1795 may be output at this time, but they are not related to this check.
DTC B1795 is output.
DTC B1795 is not output.
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
Turn the power switch off.
Disconnect the cable from the negative (-) auxiliary battery terminal, and wait for at least 90 seconds.
Replace the occupant detection ECU with a new one.
Click hereVehicle Interior>SUPPLEMENTAL RESTRAINT SYSTEMS>OCCUPANT CLASSIFICATION ECU>REMOVAL
Connect the cable to the negative (-) auxiliary battery terminal, and wait for at least 2 seconds.
| Proceed to |
|---|
| NEXT |
NEXT
Using the GTS, perform "Zero Point Calibration".
| Tester Display |
|---|
| Zero Point Calibration |
| Proceed to |
|---|
| NEXT |
NEXT