84010D
1.INSPECT INTEGRATION CONTROL AND PANEL ASSEMBLY (COMBINATION SWITCH)
Inspect the NORMAL mode switch:
| *a | Component without harness connected
(Integration Control and Panel Assembly (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 8 (B) - 13 (GND) | NORMAL mode switch being pushed and held | Below 1 Ω |
| NORMAL mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel assembly (combination switch).
Inspect the SPORT mode switch:
| *A | for 2WD |
| *B | for 4WD/AWD |
| *a | Component without harness connected
(Integration Control and Panel Assembly (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (P) - 13 (GND) | SPORT mode switch being pushed and held | Below 1 Ω |
| SPORT mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 9 (P) - 13 (GND) | SPORT mode switch being turned and held | Below 1 Ω |
| SPORT mode switch not turned | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel assembly (combination switch).
| *A | for 2WD |
| *B | for 4WD/AWD |
| *a | Component without harness connected
(Integration Control and Panel Assembly (Combination Switch)) |
Inspect the ECO mode switch:
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (ECU) - 13 (GND) | ECO mode switch being pushed and held | Below 1 Ω |
| ECO mode switch not pushed | 10 kΩ or higher |
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 7 (ECU) - 13 (GND) | ECO mode switch being turned and held | Below 1 Ω |
| ECO mode switch not turned | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel assembly (combination switch).
for 4WD/AWD:
Inspect the TRAIL mode switch:
| *a | Component without harness connected
(Integration Control and Panel Assembly (Combination Switch)) |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| 19 (B) - 13 (GND) | TRAIL mode switch being pushed and held | Below 1 Ω |
| TRAIL mode switch not pushed | 10 kΩ or higher |
If the result is not as specified, replace the integration control and panel assembly (combination switch).
Inspect the illumination:
| *a | Component without harness connected
(Integration Control and Panel Assembly (Combination Switch)) |
Apply battery voltage to the combination switch and check that the switch illuminates.
| Condition | Specified Condition |
|---|---|
| Battery positive (+) → Terminal 12 (ILL+)
Battery negative (-) → Terminal 1 (ILL-) |
Illuminates |
If the result is not as specified, replace the integration control and panel assembly (combination switch).