Home › Engine / Hybrid System › A25B-FXS (INTAKE / EXHAUST) › EXHAUST PIPE › from 2019.02
RM3620E _51 Engine / Hybrid System _080120 A25B-FXS INTAKE / EXHAUST _0388962 EXHAUST PIPE A

A25B-FXS INTAKE / EXHAUST  EXHAUST PIPE  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during front exhaust pipe assembly and tail exhaust pipe assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
·

Replacement of air fuel ratio sensor

·

Gas leak from exhaust system is repaired


Inspection After Repair
·

Poor idle, etc.

·

Engine start function, etc.


(Click here)

CAUTION:
A344784

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


PROCEDURE

Hide 17430 1.REMOVE TAIL EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A433936

Remove the 2 bolts and disconnect the tail exhaust pipe assembly from the front exhaust pipe assembly.


b.
A433937

Remove the tail exhaust pipe assembly from the 3 exhaust pipe supports.


c.

Remove the gasket from the front exhaust pipe assembly.


Hide 89467C 2.REMOVE AIR FUEL RATIO SENSOR (for Sensor 2)

Hide 17410 3.REMOVE FRONT EXHAUST PIPE ASSEMBLY

CAUTION:

To prevent burns, do not touch the engine, exhaust pipe or other high temperature components while the engine is hot.


a.
A433938

Remove the 2 nuts and disconnect the front exhaust pipe assembly from the exhaust manifold.


b.
A433939

Remove the front exhaust pipe assembly from the 2 exhaust pipe supports.


c.

Remove the gasket from the front exhaust pipe assembly.


Hide 17408 4.REMOVE TAIL EXHAUST PIPE BAFFLE SUB-ASSEMBLY

HINT:
·

Perform this procedure only when replacement of the tail exhaust pipe baffle sub-assembly is necessary.

·

If the tail exhaust pipe baffle sub-assembly is removed, replace it with a new one.



a.

Remove the 2 tail exhaust pipe baffle sub-assemblies.


Hide 17572B 5.REMOVE NO. 2 EXHAUST PIPE SUPPORT BRACKET

Hide 17573A 6.REMOVE NO. 3 EXHAUST PIPE SUPPORT BRACKET

a.

Remove the exhaust pipe support from the No. 3 exhaust pipe support bracket.


b.
A433940

Remove the 2 bolts and No. 3 exhaust pipe support bracket from the body.


Hide 17576A 7.REMOVE NO. 6 EXHAUST PIPE SUPPORT BRACKET

a.

Remove the exhaust pipe support from the No. 6 exhaust pipe support bracket.


b.
A434710

Remove the 2 bolts and No. 6 exhaust pipe support bracket from the body.


Hide 17577 8.REMOVE NO. 7 EXHAUST PIPE SUPPORT BRACKET

a.

Remove the exhaust pipe support from the No. 7 exhaust pipe support bracket.


b.
A434711

Remove the 2 bolts and No. 7 exhaust pipe support bracket from the body.