Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › FRONT DRIVE SHAFT ASSEMBLY (for 4WD/AWD) › from 2019.02
RM3620E _52 Drivetrain _077759 DRIVE SHAFT / PROPELLER SHAFT _0377447 FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD) G

DRIVE SHAFT / PROPELLER SHAFT  FRONT DRIVE SHAFT ASSEMBLY(for 4WD/AWD)  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT FRONT DRIVE SHAFT ASSEMBLY

a.
C211744

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C306388C05
1.49,1.323 1.698,1.469 0.208,0.146 10 false (A) 1.49,2.896 1.719,3.073 0.229,0.177 10 false (A) 0.104,0.104 0.417,0.302 0.313,0.198 10 false *A 0.104,1.688 0.417,1.885 0.313,0.198 10 false *B
*A for LH Side
*B for RH Side


Check whether the drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


i.

for Automatic Transaxle:

Dimension (A):
for LH Side 591.2 mm (1.94 ft.)
for RH Side 918.0 mm (3.01 ft.)



ii.

for Manual Transaxle:

Dimension (A):
for LH Side 607.6 mm (1.99 ft.)
for RH Side 909.4 mm (2.97 ft.)



iii.

for CVT:

Dimension (A):
for LH Side 603.2 mm (1.98 ft.)
for RH Side 905.0 mm (2.97 ft.)



iv.

for Hybrid Vehicle Transaxle:

Dimension (A):
for LH Side 607.6 mm (1.99 ft.)
for RH Side 906.4 mm (2.97 ft.)