Home › Drivetrain › DRIVE SHAFT / PROPELLER SHAFT › REAR DRIVE SHAFT ASSEMBLY › from 2019.02
RM3620E _52 Drivetrain _077759 DRIVE SHAFT / PROPELLER SHAFT _0377448 REAR DRIVE SHAFT ASSEMBLY G

DRIVE SHAFT / PROPELLER SHAFT  REAR DRIVE SHAFT ASSEMBLY  INSPECTION  


CAUTION / NOTICE / HINT

NOTICE:
·

When using a vise, place aluminum plates between the part and vise.

·

When using a vise, do not overtighten it.



PROCEDURE

Hide 1.INSPECT REAR DRIVE SHAFT ASSEMBLY

a.
C116430

Check that there is no excessive play in the radial direction of the outboard joint.


b.

Check that the inboard joint slides smoothly in the thrust direction.


c.

Check that there is no excessive play in the radial direction of the inboard joint.


d.

Check the boots for damage.


e.
C127699N04
1.438,1.521 1.656,1.74 0.219,0.219 10 (A)

Check whether the drive shaft dimension (A) is within specification.

NOTICE:

Keep the drive shaft assembly level during inspection.


i.

for Gasoline Model:

Length (A):
Item Length
for Torque Vectoring Differential LH Side 623.25 mm (2.04 ft.)
RH Side 609.25 mm (2.00 ft.)
except Torque Vectoring Differential 754.1 mm (2.47 ft.)



ii.

for HV Model:

Length (A):
Item Length
LH Side 718.25 mm (2.36 ft.)
RH Side 790.25 mm (2.59 ft.)