Home › Power Source / Network › A25B-FXS (BATTERY / CHARGING) › BATTERY CURRENT SENSOR › from 2019.02
RM3620E _57 Power Source / Network _080126 A25B-FXS BATTERY / CHARGING _0389094 BATTERY CURRENT SENSOR A

A25B-FXS BATTERY / CHARGING  BATTERY CURRENT SENSOR  INSTALLATION  


PROCEDURE

Hide 28850C 1.INSTALL BATTERY STATE SENSOR ASSEMBLY

a.

Attach the 2 claws to install the battery state sensor assembly to the battery current sensor holder.


b.

Attach the clamp and connect the engine wire to the battery state sensor assembly.


c.

Connect the battery state sensor assembly connector.


d.

Install the battery state sensor assembly to the auxiliary battery and tighten the nut.

Torque:
5.4 N*m (55 kgf*cm, 48 in.*lbf)


e.

Connect the No. 2 frame wire to the battery state sensor assembly with the nut.

Torque:
7.6 N*m (77 kgf*cm, 67 in.*lbf)

NOTICE:

When disconnecting the engine wire, some systems need to be initialized after the engine wire is reconnected.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION



Hide 65351A 2.INSTALL BATTERY HOLE COVER

Hide 58416K 3.INSTALL REAR NO. 2 FLOOR BOARD

Hide 58410B 4.INSTALL DECK BOARD ASSEMBLY