This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
11102A
1.INSTALL CAMSHAFT POSITION SENSOR (for Exhaust Side)
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
If reusing the camshaft position sensor, be sure to inspect the O-ring.
Install the camshaft position sensor with a new bolt.
If the camshaft position sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
Connect the camshaft position sensor connector.
11102A
2.INSTALL CAMSHAFT POSITION SENSOR (for Intake Side)
Apply a light coat of engine oil to the O-ring of the camshaft position sensor.
If reusing the camshaft position sensor, be sure to inspect the O-ring.
Install the camshaft position sensor with a new bolt.
If the camshaft position sensor has been struck or dropped, replace it.
Make sure that the O-ring is not cracked or moved out of place when installing the camshaft position sensor.
Connect the camshaft position sensor connector.
3.INSPECT FOR ENGINE OIL LEAK
12601B
4.INSTALL NO. 1 ENGINE COVER SUB-ASSEMBLY