Home › Engine / Hybrid System › A25A-FXS (EMISSION CONTROL) › DIFFERENTIAL PRESSURE SENSOR (w/ GPF) › from 2019.02
RM3620E _51 Engine / Hybrid System _076503 A25A-FXS EMISSION CONTROL _0389275 DIFFERENTIAL PRESSURE SENSOR(w/ GPF) A

A25A-FXS EMISSION CONTROL  DIFFERENTIAL PRESSURE SENSOR(w/ GPF)  INSTALLATION  


PROCEDURE

Hide 25760 1.CONNECT VACUUM TRANSMITTING HOSE ASSEMBLY

a.

Connect the vacuum transmitting hose assembly to the No. 1 tube and slide the clip to secure the hose.


Hide 89481B 2.INSTALL DIFFERENTIAL PRESSURE SENSOR

a.

Install the sensor bracket to the fuel pump flange with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


b.

Install the differential pressure sensor to the sensor bracket with the nut.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)

HINT:

Make sure there is no oil on the bracket.



c.

Connect the vacuum transmitting hose assembly to the differential pressure sensor and slide the clip to secure it.


d.

Connect the 2 clamps and differential pressure sensor connector.


Hide 89481B 3.LEARNING DIFFERENTIAL PRESSURE SENSOR

a.

Start the engine and allow it to idle until the engine coolant temperature reaches 75°C (167°F) or higher (A).


b.

Turn the engine switch off and wait for 30 seconds or more (B).


c.

Repeat the above procedures (A) and (B) 3 times.

HINT:

Procedures (A) and (B) must be repeated 3 times to complete the differential pressure sensor learning process.