Home › Engine / Hybrid System › A25B-FXS (EMISSION CONTROL) › CANISTER › from 2019.02
RM3620E _51 Engine / Hybrid System _080119 A25B-FXS EMISSION CONTROL _0389280 CANISTER G

A25B-FXS EMISSION CONTROL  CANISTER  INSPECTION  


PROCEDURE

Hide 77740 1.INSPECT CHARCOAL CANISTER ASSEMBLY

NOTICE:

When applying vacuum, the needle may waver, but as long as the needle returns to its initial position immediately, it is not a malfunction.


a.

Visually check the charcoal canister assembly for cracks or damage.

If cracks or damage is found, replace the charcoal canister assembly.


b.
A433629C01
2.573,0.656 2.802,0.406 2.802,0.406 2.948,0.406 true 1.688,0.635 1.833,0.281 1.833,0.281 1.979,0.281 true 0.833,0.708 0.729,0.406 0.729,0.406 0.625,0.406 true 0.458,0.292 0.688,0.479 0.229,0.188 10 false *a 2.021,0.177 2.24,0.365 0.219,0.188 10 false *b 3.01,0.313 3.24,0.51 0.229,0.198 10 false *c
*a Port A
*b Port B
*c Port C


Check the air flow.

i.

Using a vacuum pump, check the air flow according to the procedures below.

OK:
Measurement Condition Specified Condition
Ports B and C closed, and vacuum applied to port A (2 kPa (15 mmHg, 0.590 in.Hg)) No air leaks
Port B closed, and vacuum applied to port A (2 kPa (15 mmHg, 0.590 in.Hg)) Air flows from port C
Port C closed and air blown into port A (8 kPa (0.1 kgf/cm2, 1.2 psi)) Air flows from port B
Air blown into port A (8 kPa (0.1 kgf/cm2, 1.2 psi)) Air flows from ports B and C


If the result is not as specified, replace the charcoal canister assembly.