Home › Engine / Hybrid System › A25B-FXS (EMISSION CONTROL) › PURGE VALVE › from 2019.02
RM3620E _51 Engine / Hybrid System _080119 A25B-FXS EMISSION CONTROL _0389281 PURGE VALVE G

A25B-FXS EMISSION CONTROL  PURGE VALVE  INSPECTION  


PROCEDURE

Hide 25860 1.INSPECT PURGE VALVE (PURGE VSV)

a.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 23 to 26 Ω


If the result is not as specified, replace the purge valve (purge VSV).


b.
A405797C01
1.438,1.719 1.438,1.292 true 0.896,1.188 0.74,0.656 0.74,0.656 0.521,0.656 true 1.365,1.76 1.583,1.958 0.219,0.198 10 false *a 0.333,0.583 0.583,0.771 0.25,0.188 10 false *b 2.135,1.927 2.385,2.115 0.25,0.188 10 false *c 2.354,0.031 2.573,0.219 0.219,0.188 10 false *d
*a Port (E)
*b Port (F)
*c Air
*d Component without harness connected
(Purge Valve (Purge VSV))


Apply battery voltage between the terminals of the purge valve (purge VSV) and check that the following occurs when blowing air into the port (E).

OK:
Measurement Condition Specified Condition
Battery voltage applied between terminals 1 and 2 Air flows from port (F)
Battery voltage not applied between terminals 1 and 2 Air does not flow


If the result is not as specified, replace the purge valve (purge VSV).