Home › Engine / Hybrid System › A25B-FXS (COOLING) › THERMOSTAT › from 2019.02
RM3620E _51 Engine / Hybrid System _080121 A25B-FXS COOLING _0389724 THERMOSTAT A

A25B-FXS COOLING  THERMOSTAT  INSTALLATION  


CAUTION / NOTICE / HINT

NOTICE:

This procedure includes the removal of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.

Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION


PROCEDURE

Hide 16031 1.INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY

a.

Install a new gasket to the water inlet with thermostat sub-assembly.

HINT:

Be sure to clean the contact surfaces.



b.

Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.

Torque:
10 N*m (102 kgf*cm, 7 ft.*lbf)


c.

Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.

A435747C01
1.417,0.469 1.729,0.625 0.313,0.156 10 false *a 1.604,1.01 1.917,1.167 0.313,0.156 10 false *b 1.74,1.698 2.052,1.854 0.313,0.156 10 false *c 6.125,1.5 6.333,1.667 0.208,0.167 10 true A 1.469,1.302 1.708,1.479 0.24,0.177 10 false *e 2.281,0.698 2.531,0.906 0.25,0.208 10 false *d 0.781,1.906 1.042,2.125 0.26,0.219 10 false *f
*a View A *b 15°
*c 90° *d Upper Side
*e LH Side *f 1 mm (0.0394 in.) or higher


NOTICE:

Make sure that the tabs of the clip are within the area shown in the illustration.



d.

Connect the water inlet with thermostat sub-assembly connector.


Hide 4.ADD ENGINE COOLANT (for Engine)

Hide 5.INSPECT FOR COOLANT LEAK (for Engine)