Home › Engine / Hybrid System › A25B-FXS (LUBRICATION) › OIL PRESSURE SWITCHING VALVE › from 2019.02
RM3620E _51 Engine / Hybrid System _080122 A25B-FXS LUBRICATION _0390046 OIL PRESSURE SWITCHING VALVE G

A25B-FXS LUBRICATION  OIL PRESSURE SWITCHING VALVE  INSPECTION  


PROCEDURE

Hide 15250 1.INSPECT OIL PRESSURE CONTROL VALVE ASSEMBLY

a.
A407396C01
0.906,1.865 1.094,1.865 1.094,1.865 1.542,1.281 true 2.5,1.865 2.323,1.865 2.323,1.865 1.885,1.281 true 0.073,0.073 0.396,0.323 0.323,0.25 10 false *a 0.813,1.76 0.969,1.958 0.156,0.198 10 false 1 2.542,1.771 2.698,1.969 0.156,0.198 10 false 2
*a Component without harness connected
(Oil Pressure Control Valve Assembly)


Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
1 - 2 20°C (68°F) 6.2 to 8.2 Ω


If the result is not as specified, replace the oil pressure control valve assembly.


b.
A407397C01
0.813,1.365 1.031,1.365 1.031,1.365 1.521,0.896 true 2.698,1.375 2.49,1.375 2.49,1.375 1.906,0.896 true 0.083,0.094 0.396,0.25 0.313,0.156 10 false *a 0.708,1.271 0.865,1.469 0.156,0.198 10 false 1 2.729,1.281 2.885,1.479 0.156,0.198 10 false 2
*a Component without harness connected
(Oil Pressure Control Valve Assembly)


Connect a positive (+) lead from the battery to terminal 1 and a negative (-) lead to terminal 2.

Check that a clicking sound is heard from the oil pressure control valve assembly.

NOTICE:
·

Check that the battery voltage is between 10 and 16 V before performing this test.

·

Perform this test within 10 seconds to prevent the coil from burning out.

·

Always switch the voltage on and off at the battery side, not the oil pressure control valve assembly side.



If the result is not as specified, replace the oil pressure control valve assembly.