ALL READINESS
With "All Readiness", you can check whether or not the DTC judgment has been completed by using the GTS.
Check "All Readiness" after simulating malfunction symptoms or for validation after finishing repairs.
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Clear the DTCs (even if no DTCs are stored, perform the clear DTC procedure).
Turn the power switch off and wait for at least 2 minutes.
Turn the power switch on (IG).
Turn the GTS on.
Perform the DTC confirmation driving pattern to run the DTC judgment.
Enter the following menus: Powertrain / Rear Motor Generator / Utility / All Readiness.
| Tester Display |
|---|
| All Readiness |
Input the DTCs to be confirmed.
Check the DTC judgment result.
| GTS Display | Description |
|---|---|
| NORMAL | ·
DTC judgment completed ·
System normal |
| ABNORMAL | ·
DTC judgment completed ·
System abnormal |
| INCOMPLETE | ·
DTC judgment not completed ·
Perform the driving pattern |
If the judgment result shows INCOMPLETE, perform the DTC confirmation driving pattern again.
Turn the power switch off.
CHECK FOR DIAGNOSIS RELATED INFORMATION
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Rear Motor Generator / Utility / Diagnosis Related Information.
| Tester Display |
|---|
| Diagnosis Related Information |
Check the diagnosis related information and freeze frame data, and then write them down.
CLEAR DIAGNOSIS RELATED INFORMATION
Connect the GTS to the DLC3.
Turn the power switch on (IG).
Turn the GTS on.
Enter the following menus: Powertrain / Rear Motor Generator / Clear DTCs.
Clear the diagnosis related information and freeze frame data.
RESOLVER INITIALIZATION
Refer to the resolver initialization for the Motor Generator Control System.
RESOLVER LEARNING
Refer to the resolver learning for the Motor Generator Control System.