Home › Vehicle Exterior › EXTERIOR PANELS / TRIM › GRILLE SHUTTER SYSTEM (for HV Model) › from 2019.02
RM3620E _59 Vehicle Exterior _076404 EXTERIOR PANELS / TRIM _0375824 GRILLE SHUTTER SYSTEM(for HV Model) U

EXTERIOR PANELS / TRIM  GRILLE SHUTTER SYSTEM(for HV Model)  TERMINALS OF ECU  


CHECK SWING GRILLE ACTUATOR ASSEMBLY


B438341C08
2.927,0.177 3.344,0.427 0.417,0.25 3.75,0.177 4.167,0.427 0.417,0.25 3,0.219 3.458,0.417 0.458,0.198 10 false A85 3.385,0.229 3.698,0.427 0.313,0.198 10 false *A 3.896,0.219 4.052,0.417 0.156,0.198 10 false A 4.24,0.219 4.552,0.417 0.313,0.198 10 false *B
*A w/o Canister Pump Module *B w/ Canister Pump Module


a.

Disconnect the A85*1 or A*2 swing grille actuator assembly connector.

*1: w/o Canister Pump Module

*2: w/ Canister Pump Module



b.

Measure the voltage and resistance according to the value(s) in the table below.

HINT:

Measure the values on the wire harness side with the connector disconnected.


w/o Canister Pump Module
Tester Connection Wiring Color Terminal Description Condition Specified Condition
A85-1 (+B) - Body ground R - Body ground Auxiliary battery power supply Power switch off 11 to 14 V
A85-3 (GND) - Body ground W-B - Body ground Ground Always Below 1 Ω

w/ Canister Pump Module
Tester Connection Wiring Color Terminal Description Condition Specified Condition
A-1 (+B) - Body ground - Auxiliary battery power supply Power switch off 11 to 14 V
A-3 (GND) - Body ground - Ground Always Below 1 Ω