| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Memory | Note |
|---|---|---|---|---|---|
| C13AE | System information not received | After parking brake ECU assembly is replaced, when power switch is first turned on (IG), system cannot communicate with hybrid vehicle control ECU assembly for approximately 4 seconds | ·
Hybrid vehicle control ECU assembly ·
CAN communication system ·
Parking brake ECU assembly |
Yes | An electric parking brake system malfunction is displayed on the multi-information display. |
When replacing the parking brake ECU assembly, operate the electric parking brake switch (integration control and panel assembly) from the lock side to the release side, as the parking brake indicator light blinks when the power switch is first turned on (IG).
Turn the power switch off.
Connect the GTS to the DLC3.
Turn the power switch on (IG) and the GTS on.
Check for DTC.
Click hereBrake>PARKING BRAKE>ELECTRIC PARKING BRAKE SYSTEM (w/o Vacuum Brake Booster)>DTC CHECK / CLEAR
| Result | Proceed to |
|---|---|
| DTC C13AE and a CAN communication malfunction DTC are output at the same time | A |
| DTC C13AE is output and the master warning is displayed on the multi-information display in the combination meter assembly. | B |
| Only DTC C13AE is output | C |
| No outputs | D |
A
B
for 2WD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 2WD with NICKEL METAL HYDRIDE BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
for 4WD/AWD: Click hereEngine / Hybrid System>HYBRID / BATTERY CONTROL>HYBRID CONTROL SYSTEM (for 4WD/AWD with NICKEL METAL HYDRIDE BATTERY)>HOW TO PROCEED WITH TROUBLESHOOTING
C
D
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING