23070
1.INSTALL FUEL MAIN VALVE ASSEMBLY
Apply gasoline to a new O-ring.
| *1 | O-ring |
| *2 | Spacer |
Install the spacer and O-ring to the fuel main valve assembly.
Install the fuel main valve assembly to the fuel suction with pump and gauge tube assembly.
Make sure that the O-ring is not cut or pinched during installation.
Attach the 3 claws and install the No. 3 fuel suction support to the fuel suction with pump and gauge tube assembly.
77020A
2.INSTALL FUEL SUCTION WITH PUMP AND GAUGE TUBE ASSEMBLY
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
4.INSTALL BATTERY HOLE COVER
58416K
5.INSTALL REAR NO. 2 FLOOR BOARD
58410B
6.INSTALL DECK BOARD ASSEMBLY