This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>PRECAUTION
89458
1.INSTALL FUEL PRESSURE SENSOR
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Click hereEngine / Hybrid System>A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION
| *a | Cutout (Fuel Delivery Pipe) |
| *b | Cutout (Fuel Pressure Sensor) |
Temporarily install a new fuel pressure sensor to the fuel delivery pipe.
Make sure that the cutout of the fuel delivery pipe is aligned with the cutout of the fuel pressure sensor.
Do not allow dust or dirt to enter the sensor.
If a fuel pressure sensor is dropped or struck, replace it with a new one.
| *a | Cutout (Fuel Pressure Sensor) |
| *b | Cutout (No. 1 Fuel Pressure Sensor Holder) |
Temporarily install the No. 1 fuel pressure sensor holder to the fuel delivery pipe.
Make sure that the cutout of the fuel pressure sensor is aligned with the cutout of the No. 1 fuel pressure sensor holder.
Install the 2 bolts.
Connect the connector to the fuel pressure sensor.
17111
2.INSTALL INTAKE MANIFOLD
3.CONNECT CABLE TO NEGATIVE AUXILIARY BATTERY TERMINAL
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
Click hereGeneral>INTRODUCTION>REPAIR INSTRUCTION>INITIALIZATION
65351A
4.INSTALL BATTERY HOLE COVER
58416K
5.INSTALL REAR NO. 2 FLOOR BOARD
58410B
6.INSTALL DECK BOARD ASSEMBLY
7.INSPECT FOR FUEL LEAK
8.PERFORM INITIALIZATION
Perform "Inspection After Repair" after replacing the fuel pressure sensor.
Click hereEngine / Hybrid System>A25B-FXS (ENGINE CONTROL)>SFI SYSTEM>INITIALIZATION