This DTC is stored when the Vehicle Identification Number (VIN) is not stored in the telephone transceiver assembly or when the VIN stored in the telephone transceiver assembly and the VIN stored in the ECM do not match.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area |
|---|---|---|---|
| B15F0 | VIN Not Programmed or Mismatch - DCM | When either of the following conditions is met for 7.5 seconds or more:
·
The VIN is not stored in the telephone transceiver assembly. ·
The VIN stored in the telephone transceiver assembly and the VIN stored in the ECM do not match. |
·
SFI system ·
CAN communication system |
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 10 seconds.
Turn the GTS on.
Enter the following menus: Body Electrical / Telematics / Utility / VIN Synchronization
| Tester Display |
|---|
| VIN Synchronization |
According to the display on the GTS, perform VIN Synchronization to register the VIN to the telephone transceiver assembly.
| Proceed to |
|---|
| NEXT |
NEXT
Turn the ignition switch off.
Connect the GTS to the DLC3.
Turn the ignition switch to ON and wait for 20 seconds.
Turn the GTS on.
Check for DTCs and check that no DTCs are output.
Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for ERA-GLONASS)>DTC CHECK / CLEAR
No DTCs are output.
| Proceed to |
|---|
| OK |
| NG |
OK
Click hereGeneral>INTRODUCTION>HOW TO TROUBLESHOOT ECU CONTROLLED SYSTEMS>HOW TO PROCEED WITH TROUBLESHOOTING
NG
Check if CAN communication system DTCs are output.
CAN communication system DTCs are not output.
| Proceed to |
|---|
| OK |
| NG |
OK
for A25A-FKS: Click hereEngine / Hybrid System>A25A-FKS (ENGINE CONTROL)>SFI SYSTEM (w/o Canister Pump Module)>HOW TO PROCEED WITH TROUBLESHOOTING
for M20A-FKS: Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
NG