| Maintenance mode engine idle speed | Hybrid transaxle fluid temperature | Hybrid transaxle fluid pressure |
| 900 to 1000 rpm | 20 to 50°C (68 to 122°F) | 9.8 kPa (0.1 kgf/cm2, 1 psi) or more |
|
*: Using transmission fluid other than the above type may cause abnormal noise or vibration, or ultimately damage the transmission of your vehicle. |
|
| Hybrid transaxle fluid standard capacity (for Reference) | Classification |
| 3.9 liters (4.1 US qts, 3.4 Imp. qts) | Toyota Genuine ATF WS* |
| Front drive shaft oil seal RH | Standard depth | -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) |
| Front drive shaft oil seal LH | Standard depth | -0.5 to 0.5 mm (-0.0197 to 0.0197 in.) |
| Input shaft type T oil seal | Standard depth | 1.9 to 2.7 mm (0.0748 to 0.106 in.) |
| Wire harness: | ||
| Tester Connection | Condition | Specified Condition |
| 5 (IG) - Body ground | Power switch on (IG) | 11 to 14 V |
| Power switch off | Below 1 V | |
| 4 (STP) - Body ground | Ready ON, brake pedal depressed | 11 to 14 V |
| Ready ON, brake pedal released | Below 1 V | |
| 1 (E) - Body ground | Always | Below 1 Ω |
| Shift lock solenoid: | ||
| Tester Connection | Condition | Specified Condition |
| 4 (P) - 3 (E2) | Shift lever in P | 10 kΩ or higher |
| Shift lever not in P | Below 1 Ω | |
| 1 (SLS+) - 2 (SLS-) | Always | 112 Ω |
| Transmission Control Switch (for LHD): | ||
| Tester Connection | Condition | Specified Condition |
| 4 (IG) - 5 (S) | Shift lever in S, "+" or "-" | Below 1 Ω |
| Shift lever not in S, "+" or "-" | 10 kΩ or higher | |
| 3 (SFTU) - 2 (E) | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| Shift lever not held in "+" (Up-shift) | 10 kΩ or higher | |
| 1 (SFTD) - 2 (E) | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| Shift lever not held in "-" (Down-shift) | 10 kΩ or higher | |
| Transmission Control Switch (for RHD): | ||
| Tester Connection | Condition | Specified Condition |
| 4 (IG) - 5 (S) | Shift lever in S, "+" or "-" | Below 1 Ω |
| Shift lever not in S, "+" or "-" | 10 kΩ or higher | |
| 1 (SFTU) - 2 (E) | Shift lever held in "+" (Up-shift) | Below 1 Ω |
| Shift lever not held in "+" (Up-shift) | 10 kΩ or higher | |
| 3 (SFTD) - 2 (E) | Shift lever held in "-" (Down-shift) | Below 1 Ω |
| Shift lever not held in "-" (Down-shift) | 10 kΩ or higher | |
| NORMAL Mode Switch: | ||
| Tester Connection | Condition | Specified Condition |
| 8 (B) - 13 (GND) | NORMAL mode switch being pushed and held | Below 1 Ω |
| NORMAL mode switch not pushed | 10 kΩ or higher | |
| SPORT Mode Switch: | ||
| 9 (P) - 13 (GND) | for 2WD:
SPORT mode switch being pushed and held for 4WD/AWD: SPORT mode switch being turned and held |
Below 1 Ω |
| for 2WD:
SPORT mode switch not pushed for 4WD/AWD: SPORT mode switch not turned |
10 kΩ or higher | |
| ECO Mode Switch: | ||
| Tester Connection | Condition | Specified Condition |
| 7 (ECU) - 13 (GND) | for 2WD:
ECO mode switch being pushed and held for 4WD/AWD: ECO mode switch being turned and held |
Below 1 Ω |
| for 2WD:
ECO mode switch not pushed for 4WD/AWD: ECO mode switch not turned |
10 kΩ or higher | |
| for 4WD/AWD:
TRAIL Mode Switch: |
||
| Tester Connection | Condition | Specified Condition |
| 19 (B) - 13 (GND) | TRAIL mode switch being pushed and held | Below 1 Ω |
| TRAIL mode switch not pushed | 10 kΩ or higher | |
| Illumination Illuminates: | ||
| Condition | Specified Condition | |
| Battery positive (+) → Terminal 12 (ILL+)
Battery negative (-) → Terminal 1 (ILL-) |
Illuminates | |
| Tester Connection | Condition | Specified Condition |
| 7 (+B) - 3 (PR) | Shift lever in P | Below 1 Ω |
| 7 (+B) - 4 (PNB) | Below 1 Ω | |
| 7 (+B) - 8 (P) | Below 1 Ω | |
| 7 (+B) - 1 (DB1), 2 (N), 6 (DB2) or 9 (R) | Shift lever in P | 10 kΩ or higher |
| 7 (+B) - 3 (PR) | Shift lever in R | Below 1 Ω |
| 7 (+B) - 9 (R) | Below 1 Ω | |
| 7 (+B) - 1 (DB1), 2 (N), 4 (PNB), 6 (DB2) or 8 (P) | Shift lever in R | 10 kΩ or higher |
| 7 (+B) - 2 (N) | Shift lever in N | Below 1 Ω |
| 7 (+B) - 4 (PNB) | Below 1 Ω | |
| 7 (+B) - 1 (DB1), 3 (PR), 6 (DB2), 8 (P) or 9 (R) | Shift lever in N | 10 kΩ or higher |
| 7 (+B) - 1 (DB1) | Shift lever in D or S | Below 1 Ω |
| 7 (+B) - 6 (DB2) | Below 1 Ω | |
| 7 (+B) - 2 (N), 3 (PR), 4 (PNB), 8 (P) or 9 (R) | Shift lever in D or S | 10 kΩ or higher |
| No. 1 Transmission Shift Switch Assembly: | ||
| Tester Connection | Condition | Specified Condition |
| 1 (SDN) - 2 (ECC) | "-" (Down shift) shift paddle switch operated and held | Below 2.5 Ω |
| "-" (Down shift) shift paddle switch not operated | 1 MΩ or higher | |
| 1 (SDN) - 3 (ECC') | "-" (Down shift) shift paddle switch operated and held | Below 2.5 Ω |
| "-" (Down shift) shift paddle switch not operated | 1 MΩ or higher | |
| No. 2 Transmission Shift Switch Assembly: | ||
| Tester Connection | Condition | Specified Condition |
| 1 (SUP) - 2 (ECC') | "+" (Up shift) shift paddle switch operated and held | Below 2.5 Ω |
| "+" (Up shift) shift paddle switch not operated | 1 MΩ or higher | |