Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
42360M
1.INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
Install a new rear drive shaft inboard joint shaft snap ring LH.
42340B
2.INSTALL REAR DRIVE SHAFT ASSEMBLY LH
Coat the splines of the rear drive inboard joint assembly LH with Toyota genuine differential gear oil LX.
Coat the snap ring of the rear drive shaft inboard joint assembly LH with MP grease.
| *a | except Torque Vectoring Differential |
| *b | for Torque Vectoring Differential |
Align the inboard joint splines, and using a brass bar and hammer, install the rear drive shaft assembly.
Face the end gap of the rear drive shaft inboard joint shaft snap ring LH downward.
Do not damage the rear drive shaft oil seal.
Do not damage the rear drive shaft inboard joint boot LH.
Make sure to center the rear drive shaft assembly during installation to prevent damage to the rear drive shaft inboard joint shaft snap ring LH.
Confirm whether the drive shaft is securely driven in by checking the reaction force and sound.
3.INSTALL REAR AXLE CARRIER
4.INSTALL REAR WHEEL
5.INSPECT FOR DIFFERENTIAL OIL LEAK