Home › Audio / Visual / Telematics › TELEMATICS › MAYDAY BATTERY › from 2020.08
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0370498 MAYDAY BATTERY A

TELEMATICS  MAYDAY BATTERY  REMOVAL  


CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed, installed or replaced during the mobilephone battery removal/installation are shown below.

Replacement Part or Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures not Performed Link
Mobilephone battery Reset mobilephone battery condition Emergency call service for ERA-GLONASS:
(Click here)
for eCall:
(Click here)

PROCEDURE

Hide 86740 3.REMOVE TELEPHONE TRANSCEIVER ASSEMBLY

Hide 86742 4.REMOVE TRANSCEIVER COVER (for eCall)

a.
E441498

Detach the claw and remove the transceiver cover.


Hide 86725 5.REMOVE MOBILEPHONE BATTERY (for eCall)

a.
E441499

Disconnect the connector and remove the mobilephone battery.


Hide 86725 6.REMOVE MOBILEPHONE BATTERY (for ERA-GLONASS)

a.
E413140C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)


Loosen the 2 screws.

HINT:

The 2 screws cannot be removed because they are integrated into the battery cover sub-assembly.



b.

Detach the claw and guide as shown in the illustration to remove the battery cover sub-assembly.


c.

Lift the battery, disconnect the connector and remove the mobilephone battery as shown in the illustration.

E413141C01
0,0 0,0 false
V113147

Remove in this Direction (1)
V113148

Remove in this Direction (2)