The ECM determines the battery status according to the voltage of the BATT terminal while the engine is running (not cranking).
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | Warning Indicate | Memory | Note |
|---|---|---|---|---|---|---|
| P160200 | Deterioration of Battery Low Capacity | Battery capacity is low for 10 seconds or more when the engine is running (not cranking).
(1 trip detection logic) |
·
Battery ·
Wire harness or connector |
Charge warning light does not come on | DTC stored | SAE: P1602 |
Inspect the fuses for circuits related to this system before performing the following procedure.
If any DTCs other than P160200 are output, troubleshoot those DTCs first.
Check the charging system.
Click herePower Source / Network>M20A-FKS (BATTERY / CHARGING)>CHARGING SYSTEM>ON-VEHICLE INSPECTION
| Result |
|---|
| OK |
| NG |
OK
NG
Disconnect the ECM connector.
| *a | Front view of wire harness connector
(to ECM) |
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
|---|---|---|
| A24-1 (BATT) - Body ground | Always | 11 to 14 V |
| Result |
|---|
| OK |
| NG |
OK
Click hereEngine / Hybrid System>M20A-FKS (ENGINE CONTROL)>SFI SYSTEM>CHECK FOR INTERMITTENT PROBLEMS
NG