Home › Audio / Visual / Telematics › TELEMATICS › TELEMATICS SYSTEM (for eCall) › from 2020.08
RM3620E _56 Audio / Visual / Telematics _076049 TELEMATICS _0372098 TELEMATICS SYSTEM(for eCall) C

TELEMATICS  TELEMATICS SYSTEM(for eCall)  B15C511  Emergency Call Switch Circuit Short to Ground  B15C513  Emergency Call Switch Circuit Open  


DESCRIPTION

If the telephone transceiver assembly detects an error in the communication between the telephone transceiver assembly and the map light sub-assembly (manual [SOS] switch) as a result of the telephone transceiver assembly self check, this DTC will be stored.

DTC No. Detection Item DTC Detection Condition Trouble Area
B15C511 Emergency Call Switch Circuit Short to Ground Manual (SOS) switch impedance (Ω) is lower than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Map light sub-assembly

·

Harness or connector

·

Telephone transceiver assembly


B15C513 Emergency Call Switch Circuit Open Manual (SOS) switch impedance (Ω) is higher than the malfunction threshold for 10 seconds or more when the ignition switch is ON
·

Map light sub-assembly

·

Harness or connector

·

Telephone transceiver assembly



WIRING DIAGRAM

E231377E87
0.573,2.073 0.969,2.26 0.396,0.188 10 false H10 5.302,2.063 5.698,2.25 0.396,0.188 10 false P20 0.573,2.24 2.771,2.479 2.198,0.24 10 false Telephone Transceiver Assembly 5.302,2.208 6.865,2.604 1.563,0.396 10 false Map Light Sub-assembly (Manual [SOS] Switch) 5.375,0.792 5.771,0.979 0.396,0.188 10 false SIG1 5.396,1.594 5.823,1.781 0.427,0.188 10 false GND3 1.438,0.792 1.833,0.979 0.396,0.188 10 false SIG1 1.448,1.594 1.802,1.781 0.354,0.188 10 false SIG- 1.844,0.698 2.094,0.885 0.25,0.188 10 false 21 1.844,1.479 2.094,1.667 0.25,0.188 10 false 3 5.135,0.667 5.344,0.854 0.208,0.188 10 false 22 5.125,1.469 5.333,1.656 0.208,0.188 10 false 14

CAUTION / NOTICE / HINT

NOTICE:
·

Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Telematics System (for eCall).

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>PRECAUTION

·

When replacing the telephone transceiver assembly, make sure to replace it with a new one.



PROCEDURE

1.CHECK DTC OUTPUT
a.

Clear the DTCs.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>DTC CHECK / CLEAR

Body Electrical > Telematics > Clear DTCs
50002 459

b.

Recheck for DTCs and check if the same DTC is output again.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS SYSTEM (for eCall)>DTC CHECK / CLEAR

Body Electrical > Telematics > Trouble Codes
50001 459

Result:
Result Proceed to
No DTCs are output. A
DTCs are output. B



A

B

2.INSPECT MAP LIGHT SUB-ASSEMBLY
2.INSPECT MAP LIGHT SUB-ASSEMBLY
a.
E434905C15
2.792,1.917 2.604,1.917 2.604,1.917 2.375,1.427 true 0.844,1.948 1.042,1.948 1.042,1.948 1.208,1.417 true 0.115,0.094 0.385,0.313 0.271,0.219 10 false *a 2.854,1.833 3.365,2.115 0.51,0.281 10 false GND3 0.469,1.865 0.885,2.073 0.417,0.208 10 false SIG1
*a Component without harness connected
(Map Light Sub-assembly)


Remove the map light sub-assembly.

Click hereVehicle Interior>LIGHTING (INT)>PERSONAL LIGHT>REMOVAL


b.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
22 (SIG1) - 14 (GND3) Manual (SOS) switch not operated 410 to 414 Ω
22 (SIG1) - 14 (GND3) Manual (SOS) switch operated 81 to 83 Ω



Result:
Proceed to
OK
NG



OK

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT SUB-ASSEMBLY)

NG

REPLACE MAP LIGHT SUB-ASSEMBLY

3.CHECK HARNESS AND CONNECTOR (TELEPHONE TRANSCEIVER ASSEMBLY - MAP LIGHT SUB-ASSEMBLY)
a.

Disconnect the H10 telephone transceiver assembly connector.


b.

Disconnect the P20 map light sub-assembly connector.


c.

Measure the resistance according to the value(s) in the table below.

Standard Resistance:
Tester Connection Condition Specified Condition
H10-21 (SIG1) - P20-22 (SIG1) Always Below 1 Ω
H10-3 (SIG-) - P20-14 (GND3) Always Below 1 Ω
H10-21 (SIG1) or P20-22 (SIG1) - Body ground Always 10 kΩ or higher
H10-3 (SIG-) or P20-14 (GND3) - Body ground Always 10 kΩ or higher



Result:
Proceed to
OK
NG



OK

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY

NG

REPAIR OR REPLACE HARNESS OR CONNECTOR

4.REPLACE TELEPHONE TRANSCEIVER ASSEMBLY
a.

Replace the telephone transceiver assembly with a new one.

Click hereAudio / Visual / Telematics>TELEMATICS>TELEMATICS TRANSCEIVER>REMOVAL


Result:
Proceed to
NEXT



NEXT