AUTOMATIC HIGH BEAM SYSTEM OPERATION CHECK
| *a | Automatic High Beam Indicator on Combination Meter Assembly |
| *b | Auto High Beam Switch Indicator |
Check the operation of the automatic high beam indicator.
Turn the ignition switch to ON.
Turn the light control switch to the AUTO or HEAD position.
Move the dimmer switch to the High position.
Press the auto high beam switch (indicator illuminates).
If the auto high beam switch is turned on when the light control switch is not in the AUTO or HEAD position, or the dimmer switch is not in the High position, "To Activate Automatic Beam, Switch Headlights to High Beam" will be displayed on the multi-information display.
Check that the automatic high beam indicator illuminates.
When the forward recognition camera cannot correctly detect objects due to inclement weather such as thick fog or other visual obstructions, the automatic high beam indicator may not turn on and consequently the automatic high beam system may not operate.
Check the operation of the automatic high beam function.
At night, when driving the vehicle with the automatic high beam system in standby mode, check that the high beams automatically turn on after a short delay when all of the following conditions are met:
The vehicle speed is more than approximately 40 km/h (25 mph). (for Europe)
The vehicle speed is more than approximately 30 km/h (19 mph). (except Europe)
The area in front of the vehicle is dark.
There are no oncoming vehicles with headlights on.
There are no preceding vehicles with taillights on.
There are few streetlights along the street ahead.
The low beams may not change to high beams due to illumination from city lighting, traffic lights or billboards, or due to reflective surfaces, such as signs or signboards.
At night, when driving the vehicle with the high beams turned on by the automatic high beam system, check that the automatic high beam system turns off the high beams and returns to standby mode when any of the following conditions are met:
The vehicle speed is less than approximately 30 km/h (19 mph). (for Europe)
The vehicle speed is less than approximately 25 km/h (16 mph). (except Europe)
The level of ambient light is higher than a specified threshold.
There are oncoming vehicles with headlights on.
There are preceding vehicles with taillights on.
Light from streetlights ahead is higher than a specified threshold.
Under the following conditions, the high beams may change to the low beams.
There is interference from other illumination, such as city lighting, traffic lights or billboards, or reflective surfaces, such as signs or signboards
There is interference from the fog lights of an oncoming vehicle
Under the following conditions, the high beams may not change to the low beams.
Passing an oncoming vehicle on a curve
Preceding or oncoming vehicle appears and disappears on a continuous curve
Preceding or oncoming vehicle appears and disappears due to the median, roadside trees or other obstacle
Another vehicle cuts in front of the vehicle
When any of the following conditions are met, the automatic high beam system is canceled, and the automatic high beam indicator in the combination meter assembly turns off.
The ignition switch is turned off.
The light control switch is in a position other than AUTO or HEAD.
The low beam headlights are turned off.
The dimmer switch is set to the low beam position.
The auto high beam switch is turned off.