Home › Vehicle Exterior › LIGHTING (EXT) › AUTOMATIC HIGH BEAM SYSTEM › from 2020.08
RM3620E _59 Vehicle Exterior _077130 LIGHTING (EXT) _0474531 AUTOMATIC HIGH BEAM SYSTEM T

LIGHTING (EXT)  AUTOMATIC HIGH BEAM SYSTEM  PROBLEM SYMPTOMS TABLE  


NOTICE:
·

w/ Entry and Start System:

Before replacing the Main body ECU (multiplex network body ECU), refer to Service Bulletin.

·

When replacing the combination meter assembly, always replace it with a new one. If a combination meter assembly which was installed to another vehicle is used, the information stored in it will not match the information from the vehicle and a DTC may be stored.

·

When replacing the forward recognition camera, always replace it with a new one. If a forward recognition camera which was installed to another vehicle is used, the information stored in the forward recognition camera will not match the information from the vehicle. As a result, a DTC may be stored.

·

If the forward recognition camera has been replaced with a new one, be sure to perform Forward Recognition Camera Learning.

for Sequential Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (SEQUENTIAL RECOGNITION)

for One Time Recognition:

Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA>ADJUSTMENT (ONE TIME RECOGNITION)



Automatic High Beam System
Symptom Suspected Area Link
Automatic high beam system does not operate or automatic high beam indicator does not illuminate (low beam headlights and high beam headlights are normal) Check millimeter wave radar sensor assembly Click here
Check Data List (Front Recognition Camera High Temperature 2)
Check automatic high beam indicator
Check Data List (Auto H Beam STS0)
Check Data List (Auto High Beam Main Switch)
Perform Active Test (Automatic High Beam Indicator (Green))
Auto high beam switch
Harness or connector
Combination meter assembly
Forward recognition camera
Main body ECU (multiplex network body ECU) (for LHD)
Main body ECU (multiplex network body ECU) (for RHD)
Auto high beam switch indicator does not come ON Refer to "Automatic High Beam Switch Indicator does not Come ON" Click here