The main body ECU (multiplex network body ECU) determines the status of the automatic high beam system based on the automatic high beam system signal from the forward recognition camera.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| B124B | Automatic High Beam System | Malfunction in automatic high beam system | ·
Front camera system ·
Dynamic radar cruise control system ·
Lane control system ·
Road sign assist system ·
Pre-collision system ·
Hybrid control system (for HV Model) ·
SFI system (for Gasoline Model) ·
Electronically controlled brake system ·
CAN communication system ·
Forward recognition camera ·
Main body ECU (multiplex network body ECU) |
Main Body |
The automatic high beam system uses the CAN communication system. Inspect the communication functions by following How to Proceed with Troubleshooting. Troubleshoot the automatic high beam system after confirming that the communication systems are functioning properly.
Click hereVehicle Exterior>LIGHTING (EXT)>AUTOMATIC HIGH BEAM SYSTEM>HOW TO PROCEED WITH TROUBLESHOOTING
w/ Entry and Start System:
Before replacing the main body ECU (multiplex network body ECU), refer to Service Bulletin.
Speed sensor
Yaw rate sensor
Steering sensor
CAN communication system
Connect the GTS to the DLC3.
Turn the ignition switch to ON.
Turn the GTS on.
Enter the following menus: System Select / Health Check.
Check for DTCs.
| Result | Proceed to |
|---|---|
| Only DTC B124B is output | A |
| DTC B124B and other DTCs are output | B |
A
B
Check if a dynamic radar cruise control system, lane control system or pre-collision system warning message is displayed on the multi-information display.
Click hereEngine / Hybrid System>CRUISE CONTROL>FRONT CAMERA SYSTEM>DIAGNOSIS SYSTEM
No dynamic radar cruise control system, lane control system, road sign assist system and pre-collision system warning messages are displayed.
| Proceed to |
|---|
| OK |
| NG |
OK
for LHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for LHD)>REMOVAL
for RHD:
Click herePower Source / Network>POWER DISTRIBUTION>MAIN BODY ECU (for RHD)>REMOVAL
NG