Home › Audio/Visual/Telematics › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Clearance Warning ECU Power Source Circuit

for Preparation Click here


DESCRIPTION

This circuit is the power source circuit to operate the clearance warning ECU.

WIRING DIAGRAM


E146332E02


INSPECTION PROCEDURE

1.INSPECT FUSE (ECU-IG No. 1)


    E160643E01
  1. Remove the ECU-IG No. 1 fuse from the main body ECU.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    ECU-IG No. 1 fuse
    Always
    Below 1 Ω

  1. Install the fuse.



NG
REPLACE FUSE
OK


2.CHECK HARNESS AND CONNECTOR (DRIVE MONITOR SWITCH - BATTERY AND BODY GROUND)


    B156356E02
  1. Disconnect the J2 drive monitor switch connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard Voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J2-7 (IG) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Reconnect the drive monitor switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


3.INSPECT DRIVE MONITOR SWITCH


    E146334E02
  1. Remove the drive monitor switch (Click here).

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Switch Condition
    Specified Condition
    7 (IG) - 8 (SK)
    Clearance sonar main switch ON
    Below 1 Ω
    Clearance sonar main switch OFF
    10 kΩ or higher

  1. Install the drive monitor switch (Click here).



NG
REPLACE DRIVE MONITOR SWITCH (Click here)
OK


4.CHECK HARNESS AND CONNECTOR (CLEARANCE WARNING ECU - DRIVE MONITOR SWITCH)


    E146335E02
  1. Disconnect the H43 clearance warning ECU connector.

  1. Disconnect the J2 drive monitor switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance:
    Tester Connection
    Condition
    Specified Condition
    H43-10 (IG) - J2-8 (SK)
    Always
    Below 1 Ω
    H43-10 (IG) - Body ground
    Always
    10 kΩ or higher
    H43-21 (E) - Body ground
    Always
    Below 1 Ω

  1. Reconnect the clearance warning ECU connector.

  1. Reconnect the drive monitor switch connector.



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)