Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Display does not Dim when Light Control Switch is Turned ON

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK IMAGE QUALITY SETTING


    E137169E02
  1. Enter the display adjustment screen by pressing the "DISP" switch.

  1. Turn the light control switch to the TAIL position.

  1. Check if "Day Mode" on the display is ON.

    OK:
    "Day Mode" is ON.



NG
Go to step 2
OK

TURN "DAY MODE" SETTING OFF 

2.CHECK VEHICLE SIGNAL (DISPLAY VEHICLE SIGNAL)


    E146767E01
  1. Enter the "Display Check" mode (Vehicle Signal Check Mode) (Click here).

  1. Check that the display changes between DIM and BRIGHT according to the light control switch operation.

    OK:
    Light Control Switch Condition
    Display Condition
    TAIL or ON
    ON
    OFF
    OFF

    HINT:
    The display is updated once per second. It is normal for the display to lag behind the actual switch operation.



NG
PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)
OK

REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)