Home › Audio/Visual/Telematics › NAVIGATION / MULTI INFO DISPLAY › NAVIGATION SYSTEM

NAVIGATION SYSTEM > Cellular Phone cannot Send/Receive

for Preparation Click here


INSPECTION PROCEDURE

1.CHECK "BLUETOOTH" SETTING
  1. Check if the "Bluetooth" settings are correct.

    OK:
    "Bluetooth" settings are correct.



NG
SET SETTINGS CORRECTLY
OK


2.CHECK CELLULAR PHONE
  1. Check if the cellular phone is "Bluetooth" compatible.

    HINT:
    Some versions of "Bluetooth" compatible cellular phones may not function.

    OK:
    Phone is "Bluetooth" compatible.



NG
END (ONLY A "BLUETOOTH" COMPATIBLE CELLULAR PHONE CAN BE USED)
OK


3.CHECK SETTING
  1. Check if the cellular phone functions.

    HINT:
    The cellular phone is unable to call under any of the following conditions.
    1. The cellular phone is locked.
    2. The directory is being transferred.
    3. The line is crossed.
    4. Transmission is regulated.
    5. The power is OFF.
    6. The cellular phone is not connected to "Bluetooth" ("Bluetooth" mark is displayed while connected).

      OK:
      Above conditions do not exist.



NG
SET CORRECTLY
OK


4.CHECK CELLULAR PHONE
  1. Check if the cellular phone can make calls.

    HINT:
    When the battery is low, calls cannot be made or received.

    OK:
    Cellular phone can make calls.



NG
REPLACE CELLULAR PHONE
OK


5.CHECK RECEPTION
  1. Set the cellular phone so that it can receive calls.

  1. Place the cellular phone close to the navigation receiver assembly.

  1. Check if the cellular phone has reception according to the navigation receiver assembly.

    OK:
    Cellular phone has reception.



NG
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)