DTC P0101 Mass Air Flow Circuit Range / Performance Problem |
| DTC No. | DTC Detection Condition | Trouble Area |
| P0101 | Conditions (a), (b), (c), (d) and (e) continue for more than 10 seconds (2 trip detection logic): (a) Engine running (b) Engine coolant temperature 70°C (158°F) or higher (c) Throttle Position (TP) sensor voltage 0.4 V or more and 3.6 V or less (d) Average engine load value ratio less than 0.85, or more than 1.19 (varies with estimated engine load) Average engine load value ratio = Average engine load based on MAF meter output / Average engine load estimated from driving conditions (e) Average air-fuel ratio less than -15%, or more than 15% |
|
| Related DTCs | P0101: Mass air flow meter rationality |
| Required Sensors/Components (Main) | Mass air flow meter |
| Required Sensors/Components (Related) | Crankshaft Position (CKP) sensor, VVT sensor, Engine Coolant Temperature (ECT) sensor and Throttle Position (TP) sensor |
| Frequency of Operation | Continuous |
| Duration | 10 seconds |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs not present | P0110, P0112 - P0113 (IAT sensor) P0115, P0117 - P0118 (ECT sensor) P0120 - P0123, P0220 - P0223, P2135 (TP sensor) P0335 (CKP sensor) P0452 - P0453 (EVAP system) P2401 - P2402 (Leak detection pump fail) P2419 - P2420 (EVAP system vent valve fail) |
| Throttle position (TP sensor voltage) | 0.4 V or more and 3.6 V or less |
| Time after engine start | 5 seconds or more |
| Battery voltage | 10.5 V or more |
| Engine coolant temperature | 70°C (158°F) or more |
| Both of following conditions 1 and 2 met | - |
| 1. Averaged engine load value ratio | Less than 0.85, or more than 1.19 (varies with estimated engine load) |
| 2. Averaged air-fuel ratio | Less than -15%, or more than 15% |

| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0101) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine / Trouble Codes.
Read DTCs.
| Result | Proceed to |
| P0101 is output | A |
| P0101 and other DTCs are output | B |
|
| ||||
| A | |
| 2.CHECK AIR INDUCTION SYSTEM |
Check the air induction system for vacuum leak .
|
| ||||
| OK | |
| 3.CHECK PCV HOSE CONNECTIONS |
|
| ||||
| OK | ||
| ||