FUEL INJECTOR > REMOVAL |
| 1. DISCHARGE FUEL SYSTEM PRESSURE |
Disconnect the cable from the negative (-) battery terminal.
![]() |
Disconnect the 2 fuel pump ECU connectors.
Connect the cable to the negative (-) battery terminal.
Start the engine. After the engine has stopped on its own, turn the ignition switch off.
Crank the engine again, and then check that the engine does not start.
Loosen the fuel tank cap, and then discharge the pressure in the fuel tank completely.
Connect the 2 fuel pump ECU connectors.
| 2. REMOVE V-BANK COVER |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 3. REMOVE AIR CLEANER HOSE ASSEMBLY |
![]() |
Disconnect the vacuum hose and ventilation hose.
Loosen the 2 clamps.
Remove the air cleaner hose.
| 4. DISCONNECT NO. 2 FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the No. 2 fuel tube from the fuel pressure regulator (Click here).
| 5. DISCONNECT FUEL TUBE SUB-ASSEMBLY |
![]() |
Disconnect the fuel tube from the fuel delivery pipe (Click here).
![]() |
Disconnect the fuel tube from the No. 2 fuel delivery pipe (Click here).
| 6. DISCONNECT NO. 1 FUEL PIPE SUB-ASSEMBLY |
![]() |
Disconnect the No. 1 fuel pipe from the No. 2 fuel delivery pipe (Click here).
| 7. DISCONNECT NO. 3 VENTILATION HOSE |
![]() |
Disconnect the No. 3 ventilation hose and No. 6 wire harness connector.
| 8. REMOVE NO. 3 ENGINE COVER |
Remove the No. 3 engine cover.
| 9. REMOVE FUEL DELIVERY PIPE SUB-ASSEMBLY |
![]() |
Remove the 2 bolts and fuel delivery pipe.
Remove the 2 spacers and 4 insulators from the intake manifold.
| 10. REMOVE NO. 1 ENGINE COVER SUB-ASSEMBLY |
Remove the No. 1 engine cover.
| 11. REMOVE NO. 2 FUEL DELIVERY PIPE SUB-ASSEMBLY |
Disconnect the No. 7 wire harness connector.
![]() |
Remove the 2 bolts and No. 2 fuel delivery pipe.
Remove the 2 spacers and 4 insulators from the intake manifold.
| 12. REMOVE FUEL INJECTOR ASSEMBLY |
![]() |
Remove the fuel injector from the fuel delivery pipe, and then disconnect the injector connector.
![]() |
![]() |
Remove the O-ring from the fuel injector.