Home › Engine / Hybrid System · 2UZ-FE › ENGINE CONTROL › HEATED OXYGEN SENSOR

HEATED OXYGEN SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. CHECK HEATED OXYGEN SENSOR
  1. Disconnect the 2 heated oxygen sensor connectors.



    A159234E05
  1. Measure the heater resistance according to the value(s) in the table below.

    Standard Resistance (for Bank 1 Sensor 2):
    Tester Connection
    Condition
    Specified Condition
    1 (HT1B) - 2 (+B)
    20°C (68°F)
    11 to 16 Ω

    Standard Resistance (for Bank 2 Sensor 2):
    Tester Connection
    Condition
    Specified Condition
    1 (HT2B) - 2 (+B)
    20°C (68°F)
    11 to 16 Ω

    If the result is not as specified, replace the heated oxygen sensor.

  1. Connect the 2 heated oxygen sensor connectors.