Home › Engine / Hybrid System · 2UZ-FE › ENGINE CONTROL › AIR FUEL RATIO SENSOR

AIR FUEL RATIO SENSOR > ON-VEHICLE INSPECTION

for Preparation Click here



1. INSPECT AIR FUEL RATIO SENSOR


    A159233E06
  1. Disconnect the 2 air fuel ratio sensor connectors.

  1. Measure the resistance according to the value(s) in the table below.

    Standard Resistance (for Bank 1 Sensor 1):
    Tester Connection
    Condition
    Specified Condition
    1 (HA1A) - 2 (+B)
    20°C (68°F)
    1.8 to 3.4 Ω

    Standard Resistance (for Bank 2 Sensor 1):
    Tester Connection
    Condition
    Specified Condition
    1 (HA2A) - 2 (+B)
    20°C (68°F)
    1.8 to 3.4 Ω

    If the result is not as specified, replace the air fuel ratio sensor.

  1. Connect the 2 air fuel ratio sensor connectors.