REFRIGERANT > ON-VEHICLE INSPECTION |
| 1. CHECK REFRIGERANT PRESSURE USING MANIFOLD GAUGE SET |
This is a method to identify trouble areas by using a manifold gauge set. Read the manifold gauge pressure under the following conditions.
Test conditions:
![]() |
When the refrigerant volume is correct, the gauge reading indicates as follows:
| Pressure Side | Refrigerant Volume |
| Low | 0.15 to 0.25 MPa (1.5 to 2.5 kgf/cm2, 22 to 36 psi) |
| High | 1.37 to 1.57 MPa (14 to 16 kgf/cm2, 199 to 228 psi) |
When there is moisture in the refrigeration system:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| During operation, pressure on low pressure side cycles between normal and vacuum. | Moisture in refrigeration system freezes at expansion valve orifice, causing temporary interruption of cycle. However, when melted, returns to normal condition. |
|
|
When cooling is insufficient:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| Gas leakage from refrigeration system. |
|
|
When the circulation of the refrigerant is poor:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| Refrigerant flow obstructed by dirt in condenser. | Condenser clogged. | Replace condenser. |
When the refrigerant does not circulate:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
|
| Refrigerant does not circulate. |
|
When the refrigerant is overcharged or cooling of condenser is insufficient:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
|
|
|
|
When there is air in the refrigeration system:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| Air in refrigeration system. |
|
|
When the expansion valve malfunctions:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| Expansion valve malfunction. |
| Replace expansion valve. |
When the compressor is defective:

| Symptom | Probable Cause | Diagnosis | Corrective Action |
| Internal leakage in compressor. |
| Repair or replace compressor. |
| 2. INSPECT IDLING SPEED |
Warm up the engine.
Inspect idling speed when these conditions are established.
| Condition | Idling Speed |
| Magnetic clutch not engaged (Switch A/C OFF) | 650 to 750 rpm |
| Magnetic clutch engaged (Switch A/C ON) | 730 to 830 rpm |
| Condition | Idling Speed |
| Magnetic clutch not engaged (Switch A/C OFF) | 650 to 750 rpm |
| Magnetic clutch engaged (Switch A/C ON) | 750 to 850 rpm |